Status
Not open for further replies.

CASPER

New member
CW 800 UNIT STUCK WITH DISPLAY SHOWING "BOOT"
or Displaying "BOOT" and screen Goes Blank


Here is the HOW TO GUIDE ..

CW 800 UNIT STUCK WITH DISPLAY SHOWING "BOOT" or Displaying "BOOT" and screen Goes Blank

First Step

Turn of Receiver from the back unplug the all cables from the receiver including the antenna In cable
leave of for about 10 minutes...plug all cables back to receiver Turn Receiver ON....go to menu....Do Factory Default.

As it starts to Re-Boot and if it ends with the Display showing "BOOT" Again...

You need to shut off the power switch on the back of the again first.

Now with your Thumb of your left hand HOLD IN THE POWER BUTTON .. AT THE SAME TIME WITH YOUR OTHER HAND .. POWER ON THE CW800 FROM THE BACK.

Hold the power button approx 2 seconds more after it powers up .. and then you can let go and the "BOOT" should stay on by itself.

Now take your NULL CABLE and attach it to the back of the CW800.

Now load the factory file 102 first then with the

Loader Browse and Select the Latest BIN ( Make sure its Unziped)

Loaded the bin file into the Loader ... selected COM PORT 1 on loader..if one does not work try the other ports...

Download S/W should be selected on Loader...

Now click START .. the 0% should start counting up .. to 100% when it finishes you will see "END"

Now you should be done.

Unhook the cable from the box ..


Power the CW800 OFF from the back .. take it back to the TV and Hook the antenna back up and wire it to your TV..

Power the unit on ... and you should see the unit now start to Boot Up as It Should ......
 
Status
Not open for further replies.
Top