Clean out your receiver folks.
0. Disconnect hub and sat cables
1. Factory default and hard boot
2. Run system clean file 3 times with hard boot between each
3. Load current factory bin hard boot
4. Load new file 2 times hard boot between each
5. Re-connect sats adjust all settings and scan then power down
6. Re-connect hub and fire up on channel 340
I had pic within 2 minutes and this is the most stable my Premier has been in 2 months!
Post back if it works for you please!
0. Disconnect hub and sat cables
1. Factory default and hard boot
2. Run system clean file 3 times with hard boot between each
3. Load current factory bin hard boot
4. Load new file 2 times hard boot between each
5. Re-connect sats adjust all settings and scan then power down
6. Re-connect hub and fire up on channel 340
I had pic within 2 minutes and this is the most stable my Premier has been in 2 months!
Post back if it works for you please!