rascal7887

New member
Hello, I am a newbie and am having problems installing the WF and getting it to work. I have followed every instruction for installing, and even followed the one to install file V0146. I have did factory default and rescanned in several times, I have tried files 100322 - 100320...and 100614 - 100616 I still get the no video or audio. The forecaster gives me the forecast, but can not go any further...Below is what I see when I try to load the files as far as the S/W. Do not know what other info is needed.

DX-X00-N APP 1.00.03 = 100322
DX-X00-N APP 2.00.03 = 100320
DX-X00-N APP 1.00.05 = 100614
DX-X00-N APP 2.00.05 = 100616

I am totally lose and confused...

:suicide2:
 

rascal7887

New member
I am using an Ultra...and even followed the instructions for the link WF Latest Instructions & Troubleshooting.
 

Beware Beware

PreferredByPete.com Enthusiast
The 614 for the defective WF works good.
All you have to do is first flash box with the 614 and update WF....
Then flash with 624 and also update WF
Factory reset and rescan.....
 

Beware Beware

PreferredByPete.com Enthusiast
Weather Forecaster Installation Instructions

This setup is almost as easy as the old standalone days... It is definitely the easiest of any other I have seen....this is assuming your receiver is already hooked up to tv and satellite dish and ready to go.

Personally, I would do a factory default, reset settings, and do a fresh scan of the sats.

Make sure your WF is hooked to your receiver via serial cable, make sure your network cable is hooked to your internet connection, via whatever your source, direct, router, etc... and also make sure power cable to WF is plugged in, then...

1. Load Factory firmware
Upgrade main S/W to the receiver through USB.
-. Ultra lite : PFTAUSW-100322UL (Ultra lite) or
-. Ultra : PFTAUSW-100322U (Ultra)

2. Go to installation => Serial Setup => Network Setup => Network setting => put your IP
-. If you use DHCP, just put the DHCP in Network setting. (Most will use DHCP)

3. Go to installation => Serial Setup => Network Setup => Network S/W upgrade => Start Upgrade.
-. Then the S/W for WF will be upgrade automatically.

Once the above is done, your stb flashed, used the serial setup to set networking settings, updated the WF via Network s/w upgrade... you are ready to test the weather feature.

To do this:

1. Go to installation => Serial Setup => Regional Weather
2. Choose Region => Pick your location or close by location
3. Move down to Get Regional Weather => Press Ok
4. Depending on your internet connection it may take up to 2 minutes to download Regional Weather Information.

Note: Weather Forcast feature is only available on factory firmware (100318 or 100322)

To get channels:

4. Load Latest firmware
Upgrade main S/W to the receiver through USB.
-. Ultra lite : PFTAUSW-100320UL (Ultra lite) or
-. Ultra : PFTAUSW-100320U (Ultra)

5. Go to installation => Serial Setup => Network Setup => Network S/W upgrade => Start Upgrade.
-. Then the S/W for WF will be upgrade automatically.
 

CASPER

New member
there are new files posted today for WF have u check the files forum....for your ?????????????
 
Top