CASPER
New member
How to Properly load your Coolsat 7100 using the RS232 Cable
NOTE
ALWAYS Unplug your receiver BEFORE disconnecting Or Connecting your Coax cable Or RCA cables !! FAILURE to do so WILL damage your receiver !
1) Download and unzip both the ( F2ATV.com COOLSAT7100_FAC_V0112 and NorW latest release
2) Connect your receiver to your computer using your RS232 cable.
3) Open your Coolsat 7100 Loader click the file button and load your Coolsat_7100_Fac_Vo112 into your loader
4) Timing is everything on this step ! Put your mouse over the download button and as soon as you turn the Back power switch on your receiver ON click the download button
If your to slow it will NOT load and you must Repeat this step !
5)When your receiver reboots itself Or you see this ---- turn off the back switch and reconnect it to your TV then click Menu on your remote and then go to Installation screen and select SYSTEM RECOVERY and click YES to (System restore to Factory Default) when the factory reset is finished set the Language of choice and then set your time zone. After setting the time zone the receiver will ask if you want to Auto detect your satellites and switch settings. Say NO at this time !
6)Now Repeat the First 5 steps to load the Latest Coolsat7100_NorW-bin !
BUT this time say YES to Auto Detect and it will auto set your LNB type and switch settings and then scan All the satellites your pointed at !
NOTE
ALWAYS Unplug your receiver BEFORE disconnecting Or Connecting your Coax cable Or RCA cables !! FAILURE to do so WILL damage your receiver !
1) Download and unzip both the ( F2ATV.com COOLSAT7100_FAC_V0112 and NorW latest release
2) Connect your receiver to your computer using your RS232 cable.
3) Open your Coolsat 7100 Loader click the file button and load your Coolsat_7100_Fac_Vo112 into your loader
4) Timing is everything on this step ! Put your mouse over the download button and as soon as you turn the Back power switch on your receiver ON click the download button
If your to slow it will NOT load and you must Repeat this step !
5)When your receiver reboots itself Or you see this ---- turn off the back switch and reconnect it to your TV then click Menu on your remote and then go to Installation screen and select SYSTEM RECOVERY and click YES to (System restore to Factory Default) when the factory reset is finished set the Language of choice and then set your time zone. After setting the time zone the receiver will ask if you want to Auto detect your satellites and switch settings. Say NO at this time !
6)Now Repeat the First 5 steps to load the Latest Coolsat7100_NorW-bin !
BUT this time say YES to Auto Detect and it will auto set your LNB type and switch settings and then scan All the satellites your pointed at !