Domando1069
VIP Member
Got this from another site, so all credit for this goes to them c&p
1) Turn OFF the receiver and unplug the power from the outlet
2) Unscrew 5 screw (2 on each side, and 1 in the back) to remove the case cover
3) Remove the module bracket
(after the bracket been removed)
4) Remove the sticker in the rear
3) Connect 2 cables to the sub-board
4) Connect the sub-board to the module .
Please be careful that Parts mounted surface should be up.
5) Connect LNB Power cable from the power supply board to the sub-board connector.
6) Connect the cable with the smaller connector from the sub-board to the connector of PCB
Please make sure the red cable should be in #1 pin.
7) Connect the cable with the smaller connector from the sub-board to the connector of PCB
Please make sure the red cable should be in #1 pin.
8) Fit the module thru the hole(reserved for the UHF remote antenna)in the rear of the receiver tight it
up using nut & washer
9) Connect a loop thru cable connecting the IF Output and the module input
10) Finishing job
1) Turn OFF the receiver and unplug the power from the outlet
2) Unscrew 5 screw (2 on each side, and 1 in the back) to remove the case cover
3) Remove the module bracket
(after the bracket been removed)
4) Remove the sticker in the rear
3) Connect 2 cables to the sub-board
4) Connect the sub-board to the module .
Please be careful that Parts mounted surface should be up.
5) Connect LNB Power cable from the power supply board to the sub-board connector.
6) Connect the cable with the smaller connector from the sub-board to the connector of PCB
Please make sure the red cable should be in #1 pin.
7) Connect the cable with the smaller connector from the sub-board to the connector of PCB
Please make sure the red cable should be in #1 pin.
8) Fit the module thru the hole(reserved for the UHF remote antenna)in the rear of the receiver tight it
up using nut & washer
9) Connect a loop thru cable connecting the IF Output and the module input
10) Finishing job
Last edited: