trebor5961
New member
Lost picture with NPN_1.28 and NPN_8.06_Factory
Did factory resent from Nano2 menu, then Loaded NPN_8.10_Factory then NPN_1.29.
system files show: SW: MV01.29 (Jun16) LDR 1.08
HW ver: 1.00
USB 2.0 driver: 1.00
Nano2 (2)
Problem is Nano2 will not auto populate IP set-up and no lights flashing on dongle. Manual load of IP settings does not help to configure IKS setting. Resetting router had no effect, used laptop to confirm internet cable is good. Any ideas?
I
Did factory resent from Nano2 menu, then Loaded NPN_8.10_Factory then NPN_1.29.
system files show: SW: MV01.29 (Jun16) LDR 1.08
HW ver: 1.00
USB 2.0 driver: 1.00
Nano2 (2)
Problem is Nano2 will not auto populate IP set-up and no lights flashing on dongle. Manual load of IP settings does not help to configure IKS setting. Resetting router had no effect, used laptop to confirm internet cable is good. Any ideas?
I