Status
Not open for further replies.

BROWNNOSE

BOOTLICKER
courteousy of fttalk
if you have upgraded to 1.29 and still not getting picture, here are the steps to go back to 1.28:

u will need a null-modem cable, a computer with serial port, and the CNX Loader tool
u can use the 8.05 LDR file with the tool to restore the Factory file ; make sure you unzip the files before you try flashing; there is a pdf file in the zip which gives instructions on how to do this Factory file restore

once you have restored the Factory file and the flash is successful, when you turn on CNX, select Load Defaults from the menu that pops up; when the box is powered off and on, you will see the familiar CNX menu

from there, you can flash the 8.08NPN file found here via USB (make sure you select Boot Loader Upgrade from menu)
once STB is rebooted, you can flash the 1.28NPN file via USB (make sure you select S/W Upgrade from menu)

you can confirm your file info versions by going to System Information under Utility menu; it should read:

SW : MV01.28 (Feb 04) LDR 1.08
HW VER : 1.00
USB 2.0 DRIVER : 1.00
NANO 2 (2)

u don't need to register IKS again, just make sure you have IP...set up your sats and rescan; picture should come in when you leave it on 300 for a minute or two
 
Status
Not open for further replies.
Top