Factory file should be loaded first then
follow these steps
Proper Setup Procedure (tested on the original Nano):
1) IF YOU HAVE A NANO: Obtain these three bins and put them on USB stick:
NAN_7.10_Factory.NPB ("factory" bin)
NAN_4.22.NPB (the "422" bin)
IF YOU HAVE A DIFFERENT MODEL: Same as above just the ones for that instead.
2) Connect the USB stick to the front USB port, fire up the STB
3) Go to menu "Utility" -> "USB"
4) Navigate to the factory bin, select it, install using "Bootloader" option
5) Wait for it to finish and reboot. Sometimes it will sit there with 0
on the front panel, press the remote power button if so (it's in soft-off)
6) Go to menu "Utility" -> "Factory Default", enter PIN, say yes
7) Repeat step 3-6 but with the "422" bin instead
8) Connect serial. Fire up cnxemu. Double check /dev/pts/ path and set it in
your SSSP client. Fire up the SSSP client. (use "screen" or two terms)
9) Go to menu "Utility" -> "System Information" and watch the bottom line for
it to change from "unknown" to "cnxemu v0.1a" (it will take a second)
This verifies your serial connection and that cnxemu is ready.
10) Set up your satellites and do an autoscan, etc
11) Go to a channel you know your IKS provider handles, watch TV.