CASPER
New member
The do not's first:
Do Not "DO NOT INTERUPT THE FLASHING PROCESS ONCE YOU POWER ON THE BOX"
Do Not "SELECT BOOT ON THE SOFTWARE (USE MAIN ONLY)"
1. Have the power turned off on the back of your box .
2. Connect (RS232 Null Modem) cable between PC & NFusion box.
3. Turn the back Power button on.
4. Select your serial port by clicking the COM button (COM 1 is default). Default Baud Rate is set at 115200.
5. Click open file and select an Nfusion File to be downloaded to your receiver.
6. Click Start NFusing and a box will pop up that says "Please REBOOT your STB after clicking OK.
7. Cllick OK then turn on or off by the Front power button of your box or use your Remote and the Software will start loading.
8. Do not touch the unit untill you see 0000 on front panel that is on first load
If you reflash your box after you scan satellites, a channel number will show on the display instead of 0000. Once you see 0000 or channel number you are finished. Now watch tv.
Do Not "DO NOT INTERUPT THE FLASHING PROCESS ONCE YOU POWER ON THE BOX"
Do Not "SELECT BOOT ON THE SOFTWARE (USE MAIN ONLY)"
1. Have the power turned off on the back of your box .
2. Connect (RS232 Null Modem) cable between PC & NFusion box.
3. Turn the back Power button on.
4. Select your serial port by clicking the COM button (COM 1 is default). Default Baud Rate is set at 115200.
5. Click open file and select an Nfusion File to be downloaded to your receiver.
6. Click Start NFusing and a box will pop up that says "Please REBOOT your STB after clicking OK.
7. Cllick OK then turn on or off by the Front power button of your box or use your Remote and the Software will start loading.
8. Do not touch the unit untill you see 0000 on front panel that is on first load
If you reflash your box after you scan satellites, a channel number will show on the display instead of 0000. Once you see 0000 or channel number you are finished. Now watch tv.