CASPER
New member
Tronics v202_FEMU_PUFF
C/P
I have been testing this bin for about 2 hours and it seems to be working fine.
As with the last FEMU bin there are a couple of issues that still are present.
1) if you power your box off for an extended amount of time ( during my testing 10 minutes was not a problem but 30 minutes was) you will lose your channel list and have to re-scan.
2) I have not tested for channel master function but reports are that channel master continues to not work with the FEMU bins.
I recommend that once you scan your channels that you do not turn your receiver off.
Some people have requested a step by step guide for using my bins.
I will post the steps I take that work for me, your mileage may vary.
1) load the bin.
2) scan your first sat. ( I use blind scan personally )
At this point after all channels on the first sat have been found I will power cycle the receiver. The channels you just scanned should persist the hard boot provided you just power off the receiver with the back switch wait a second or two and power it back up.
3) proceed and scan all other satellites, I do not power cycle the receiver after scanning any of the other satellites, only after the first one.
4) Exit out to TV and then press 8282, turn off autoroll but NOT KEYCODE and set default keys.
5) exit back to tv and enjoy.
Even though we did not have any problems with needing to JTAG with the last file I released I am still going to put the following warning just to cover my butt so to speak.
JUST IN CASE OF UNFORESEEN ISSUES I RECOMMEND YOU KNOW HOW TO JTAG IF YOU USE THIS BIN!!!
C/P
I have been testing this bin for about 2 hours and it seems to be working fine.
As with the last FEMU bin there are a couple of issues that still are present.
1) if you power your box off for an extended amount of time ( during my testing 10 minutes was not a problem but 30 minutes was) you will lose your channel list and have to re-scan.
2) I have not tested for channel master function but reports are that channel master continues to not work with the FEMU bins.
I recommend that once you scan your channels that you do not turn your receiver off.
Some people have requested a step by step guide for using my bins.
I will post the steps I take that work for me, your mileage may vary.
1) load the bin.
2) scan your first sat. ( I use blind scan personally )
At this point after all channels on the first sat have been found I will power cycle the receiver. The channels you just scanned should persist the hard boot provided you just power off the receiver with the back switch wait a second or two and power it back up.
3) proceed and scan all other satellites, I do not power cycle the receiver after scanning any of the other satellites, only after the first one.
4) Exit out to TV and then press 8282, turn off autoroll but NOT KEYCODE and set default keys.
5) exit back to tv and enjoy.
Even though we did not have any problems with needing to JTAG with the last file I released I am still going to put the following warning just to cover my butt so to speak.
JUST IN CASE OF UNFORESEEN ISSUES I RECOMMEND YOU KNOW HOW TO JTAG IF YOU USE THIS BIN!!!