CASPER
New member
The E010 is message displayed on the front of the Receiver when the TSOP thinks it sees a corrupt file loaded on Boot Up, most of the time it is a false Negative. Meaning the Receiver needs to be rebooted but with a long rest so as to clears it's memory (so to speak).
Before trying anything, turn off the Receive and unplug everything and leave it unplugged from the wall outlet overnight 4 to 6 hours. With the Receiver unplugged, short out the Prongs of the power cords, together, to discharge the Circuits of any static charge. Use any metallic object to short out the 2 prongs on the plug.
Plug in the Receiver to the Wall outlet.
Turn it on, if the E010 error message is gone, great if it is not then follow the procedures below.
1) Download and unzip both the Limesat Loader and Factory bin V1.3 to your PC.
2) Connect your receiver to your computer using your Null Modem cable.
3) Open your Limesat Loader and select the factory bin V1.3.
4) Select the appropriate com port (port 1 is recommended)
5) Leave Receiver OFF.
6) In the Loader Screen, click the "Start" then Turn Rear Switch ON.
7) The Loading should start, do not interrupt it till done.
8) If it fails to load, try timing Sequence Procedure as follows.
9) Timing is very important in this Procedure ! Put your mouse over the "Start" button and as soon as you turn the Rear switch on your receiver ON click the "Start" button. If your to slow it will not load and you must repeat this step !
10) Wait until it finishes and reboots itself, then load the latest fix, via the USB Port.
11) Proceed to Menu Antenna setup and Set up your satellites and scan when you have Proper Sat lock
12) Click Menu, Network Settings, IP=Box Info and confirm that you Hsave Connect [2]. If not start your own thread and ask for assistance
NOTE
Always Unplug your receiver BEFORE disconnecting Or Connecting your Coax cable. FAILURE to do so MAY damage your Switches or LNBs or your Receiver.
Before trying anything, turn off the Receive and unplug everything and leave it unplugged from the wall outlet overnight 4 to 6 hours. With the Receiver unplugged, short out the Prongs of the power cords, together, to discharge the Circuits of any static charge. Use any metallic object to short out the 2 prongs on the plug.
Plug in the Receiver to the Wall outlet.
Turn it on, if the E010 error message is gone, great if it is not then follow the procedures below.
1) Download and unzip both the Limesat Loader and Factory bin V1.3 to your PC.
2) Connect your receiver to your computer using your Null Modem cable.
3) Open your Limesat Loader and select the factory bin V1.3.
4) Select the appropriate com port (port 1 is recommended)
5) Leave Receiver OFF.
6) In the Loader Screen, click the "Start" then Turn Rear Switch ON.
7) The Loading should start, do not interrupt it till done.
8) If it fails to load, try timing Sequence Procedure as follows.
9) Timing is very important in this Procedure ! Put your mouse over the "Start" button and as soon as you turn the Rear switch on your receiver ON click the "Start" button. If your to slow it will not load and you must repeat this step !
10) Wait until it finishes and reboots itself, then load the latest fix, via the USB Port.
11) Proceed to Menu Antenna setup and Set up your satellites and scan when you have Proper Sat lock
12) Click Menu, Network Settings, IP=Box Info and confirm that you Hsave Connect [2]. If not start your own thread and ask for assistance
NOTE
Always Unplug your receiver BEFORE disconnecting Or Connecting your Coax cable. FAILURE to do so MAY damage your Switches or LNBs or your Receiver.