Status
Not open for further replies.

CASPER

New member
Viewsat MaxHD How to

--------------------------------------------------------------------------------

C/P Credit to Anyonomus for the work.

This may need a little tweaking as I go over it..as It is a work in progress..
Thanks to heretoday
Updated & corrected information by Anyonomus

and again by bpg and Tech07

VS MaxHD Setup Guide Using USB

1. First you must download and unzip (extract) the newest yymmdd.peg from our files section to your computer Unzip(extract) the file to your desktop for easy retrieval .

2. Insert your Memory Stick in your PC and transfer the extracted(unzipped)
.peg file from your computer into the usb drive.

3. Shut the FTA Receiver OFF with the back switch.

4.Insert the USB drive into your STB. (either rear or front -just make
sure you enable REAR USB or FRONT USB in the menu -under USER SETTING OPTION and use the one you chose)

5.Turn the FTA ON with the back switch (If the STB doesn't recognize your flashdrive, make sure the drive is formatted to FAT32) and place extracted file on drive again as formatting will erase all that is on the drive.

6. Press Menu and then arrow "right/left" until System Information shows..

7.Use Arrow down/up and Select Receiver Upgrade and press OK

8.Go down to the bottom of the window, select USB and press OK

A new window opens with files. Select your .peg file and press OK.

**************************************
VERY IMPORTANT. DO NOT TURN THE POWER OFF

Let the receiver finish and reboot on its own!!!
**************************************

9. Press Menu key, Use arrow right/left and choose Installation

10.Press Arrow down and Select Antenna Setup and press OK

11.Select your Sat. and settings for LNB power/type ,also Here ,if you have a
Diseqc switch enter the port #,
Motor or Legacy SW (appropriate to your setup).

12.Press Exit and select Yes for saving the settings

13.Your back to Antenna Setup screen

14. Set up each Sat you have by repeating starting from step 9

15. from Installation menu Select Auto Scan and Press OK
You can change the sat you want to scan by using the F1 to show sats and arrow up/down
to select the sat to scan.

CAUTION select ONE sat at a time by using the "OK" to check or uncheck the proper sat.

Use "Exit" to leave sat selection and arrow up/down to Select "Scan Start" and press OK.

Do this for all the Sats you are pointed at(one at a time).

16. Exit and save the settings for each sat.

17. Wait for Autoroll and watch TV
 
Status
Not open for further replies.
Top