Receiver: Pansat 2700A
Want to get: Internation Channels EchoStar 61.5
I have been using this receiver for a few months and it has been working. I added the usual bin files for autoroll.
When I performed this last Boot 75 upgrade, I clicked the Factory Settings and it erased all my channels. I then loaded the Boot 75 file and the latest bin 120 file.
When I go to configure my satellites, selected Echo 3/Ku, and entered the following settings:
LNB TYPE - STANDRED
LNB FREQ - 11250
22KHZ - OFF
DISEQC - OFF (i have no switch)
SKEW -
TP -
POSITI SET - Disable
Satellite Scan - ALL
When I change the TP, I see the quality and signal being > 80%. When I click 'Ok' to save and 'Exit' to scan satellites for the list of channels, it saves the TP back to 1 (which has no quality).
I have tried to Scan Satellites, Scan TP, Advance Scan, and it tries and goes up to like 18%, but doesn't go all the way.
What am I doing wrong?...sorry for the long message, but had to be clear. Thank you very much for any help.
Want to get: Internation Channels EchoStar 61.5
I have been using this receiver for a few months and it has been working. I added the usual bin files for autoroll.
When I performed this last Boot 75 upgrade, I clicked the Factory Settings and it erased all my channels. I then loaded the Boot 75 file and the latest bin 120 file.
When I go to configure my satellites, selected Echo 3/Ku, and entered the following settings:
LNB TYPE - STANDRED
LNB FREQ - 11250
22KHZ - OFF
DISEQC - OFF (i have no switch)
SKEW -
TP -
POSITI SET - Disable
Satellite Scan - ALL
When I change the TP, I see the quality and signal being > 80%. When I click 'Ok' to save and 'Exit' to scan satellites for the list of channels, it saves the TP back to 1 (which has no quality).
I have tried to Scan Satellites, Scan TP, Advance Scan, and it tries and goes up to like 18%, but doesn't go all the way.
What am I doing wrong?...sorry for the long message, but had to be clear. Thank you very much for any help.