Status
Not open for further replies.

CASPER

New member
How To X1 Dongle




How to, all releated on X1 Dongle attached on PDF files:

This is what I did, at 1st get it,

1. Plug X1 Dongle to my Settopbox
2. Plug power supply to X1 Dongle
3. Plug the USB BlueTooth to your USB port PC or LP
4. Down at the Windows Start Bar look the small logo

5. Right click at Logo 'Open Blue Tooth Setting"
6. Click at TAB button say "COM Port" click 'Add' then click OK
will pull up the Com Port is not in USE " In my case show COM5.
:: I need to change that Com5 to 1 to 4. In some case will detect 2-3-4..

7. Go to Device at Bluetooth setting click "Add" will show a wizard ,run it will detect all your Bluetooth device you have iin some cases your Cell phone.

8. After is detected all device will show up chose "Fireflay7643" click NEXT , then chose "USE the passkey found in the documentation" and in the white
box type ( 1234) Click next and wizard will run you will see Outgoing port and Incomging port ,
Hit "Finish" then OK

In may case show Comport Outgoing 6 & Incoming 7.
You can set up twice port same # by going to Device manager.

Now u ready to use Sonysat loader..

Have fun
 

Attachments

  • q&ax1don.pdf
    18.1 KB · Views: 7
  • x1dongle.pdf
    112.8 KB · Views: 4
  • x1dongle-ref-guide.pdf
    139.1 KB · Views: 4
  • x1don-specs.pdf
    414.4 KB · Views: 6
Status
Not open for further replies.
Top