Status
Not open for further replies.

Rumas

Administrator
Staff member
The settings look right.

See if you get channel 100 if you do you have echostar 6,8 satellite.

Then check channel 200(cnn) if you get it you have echostar 7 satellite and your set up right.

If you are missing one satellite, try changing the DiSEqC Port one number at a time till 200 and 100 both work. Make sure you are on echostar package when you do this.

Echostar 7 (119)
LNB Power ON
LNB Type STANDARD - OCS-DP
LNB Freq 11250
22KHz OFF
TP Freq 12239
Search option ALL
DiSEqC Port 1
Motor OFF (if none)
Legacy SW NONE


Echostar 6,8 (110)
LNB Power ON
LNB Type OCS-DP
LNB Freq 11250
22KHz OFF
TP Freq 12224
Search option ALL
DiSEqC Port 2
Motor OFF
Legacy SW NONE
 

Haven

New member
I do not have the channel 100.
My echostar is 8,10, not 6,8 (do I have to setup differently?)
Should I try all different port in echostar 7 and 8,10 in case I dont get channel 100 and 200?

Thanks
Haven
 

Haven

New member
Well, I got my receiver working now with the channels I wanted and now that I was going to fix my other receiver with all the same setup it doesnt work. Why? I see the channels but they are blank and it says "no sound and video"
Thanks
Haven
 

darklist

VIP Member
this is your post and what ever you see is red that has to change to the fallowing

The auto roll is OFF with the new keys code (I put the new codes on Nagra)

The installation - antenna setup is
Satellite - Echo Star 7
LBN Power - On
LBN Type OCS-DP
LNB Freq - 11250
22KHz - Off
TP Freq - 12224
Search option - All
DiSEqC 1.0 - Port 1
Motor - Off
Legacy SW - None



so you must turn the Autoroll on if you have the last update and you must change you lnb type to standard unless if you have Dp Lnb dish you will be fine
:cool:
 
Last edited:
Status
Not open for further replies.
Top