flairworms

New member
Newbie here! Loaded the new file but still no channels. As well I had each channel showing twice. I then deleted all channels but cannot get any back even with new file. Help friends.....
 

Domando1069

VIP Member
Flairworm
Do a factory reset, load the factory bin, then install new bin and reprogram your receiver, everything should be ok then.
 

flairworms

New member
Thanks. I must be doing something wrong as this did not work. I did a factory reset on the actual unit then loaded the factory bin. As soon as the factory bin was loaded I then loaded the most current bin. I than hooked my system up and did a blind scan but now shows auto roll processing. If I take the auto roll off then the message says no audio no video. Does anyone know what I did wrong?
 

flairworms

New member
Hello again, Ok....I have made some progress...I think. My system is stuck at "Auto Rolling" and will not move..please help
 

flairworms

New member
I have re-loaded the latest bin but the autoroll messge is on all channels and will not go away. Could there be anything else? One thing I have noticed is my TP Freq does not save to a setting that I want it too. Could this be an issue? Basically when I go into the Antenna selection I have no green bars. When I change the TP Freq to a certain level I get green bars but it does not allow me to save the level I have changed it to...Any Ideas... THanks so much to all who have been helping and will continue to help.
 

alanpolus

New member
viewsat xtreme and ultra are down all receivers down at 12:00pm today
we need new keys or maybe new file fix.
any help?:twitcy:
 

darklist

VIP Member
check all ways the file section for new update and receivers model section what you need , just let us know if your satellite gos down and what is doing , more information you give is better to get you help
:idea:
 
Top