On my MAXHD I can not get any signal strength to come up on the meter for 110 or 119. I have all the correct settings. The strange part about it is if I put the ant setting to say ANIK 3 (118) port 1, I get echostar 7 with a 71 strength. and if I put it on and then if I switch it to port 2, I get 87 strength for echostar 10,11..So I set Anik3 on port 1 and 110 on port 2 then scan channels . the only problem is I get NO INFORMATIN on alot of the channels. But if I dont do it that way I dont get channels at all. Somewhere I read a similar problem and it was suggested that maybe the card inside the box(the one to get local channels and whatever) could be bad. I just want to know if anyone has any insight on this before I spend the money on a new card..Thanks