scuggers1

New member
I haven't been able to understand the fix sequence [do what in which order?]
to be able to save Dolby audio with the latest bin A/R fix.

I don't see a note on how to fix this and I've read and looked for it. anyone else having trouble with this?

what's the sequence of events to do the proper install? update stb, scan sat, etc?:goofy:
 

scuggers1

New member
The solution is you must use a jump drive and load the factory 1.19 bin over your 1.17 then you can load the Latest PGM bin. The 1.17 does not recognize the rs232 cable thus resulting in a failed load everytime. Here is what I did step by step.

1. Load the 1.19 and Latest PGM bin on the jump drive

2. Turn on the STB (back switch then power on using the remote) with the jump drive inserted go to Menu,System Information, Receiver Upgrade, USB, then find the 1.19 bin that you loaded onto the jump drive.

3. Once you start to load it should take 10-15 sec then reboot automatically when it comes back up go back following the previous steps and then load the PGM bin it will reboot again. When it comes back up go to Installation, Antenna Setup and input your settings for 110/119.

4. When that step is complete go back to Installation and choose Auto Scan once here hit the f1 and choose the sats that you setup in the Antenna Setup section i.e. 110/119. Hit exit then OK to start scan. Once done with the sat scan turn to any channel and let it sit for 10 min or so and wait for it to autoroll the keys and watch tv

Files that are Needed.

V0119ULTRA-VIEWSAT
PFTAUSW-( Latest PGM )

Sat 119: EchoStar 7
1) LNB power on
2) LNB Type (“OCS-DP” for DishPRO LNB, etc.)
3) LNB freq 11250
4) 22khz OFF
5) TP freq 12239
6) Search option ALL
7) Disecq Port (1 or whatever)
8) Motor off
9) Legacy SW None

Sat 110: EchoStar 8, 10
1) LNB power on
2) LNB Type (“OCS-DP” for DishPRO LNB, etc.)
3) LNB freq 11250
4) 22khz OFF
5) TP freq 12224
6) Search option ALL
7) Disecq Port (2 or whatever)
8) Motor off
9) Legacy SW None
 
Top