PS
Always best to Check the Newlink to be certain that the Device you have is in fact a Newlink
Plug in the Newlink Device to the receiver and the Ethernet Cable.
Run Wiznet Ver 2.1.0, click Search.
If Wiznet reports Ver 1.4, 1.9, 2.1 or 2.2 you have a I-Hub and you should load Bin 418 instead.
If wiznet reports Ver 1.1 then proceed to load the Newlink V1.2 which must be loaded 1st ....Via the USB Loading Procedure.
If Wiznet reports V1.2 then Proceed to Load Newink HD6
To Load Bin HD6:
1) Turn Off receiver with rear switch
2) New connected to Receiver and to the Router via the Ethernet Cable
2) Turn it on and tune to CH 101, make certain you have Picture.
3) Insert USB stick with Bin HD6
4) Go to USB, and Update Software and wait till done
5) Once Bin HD6 is loaded, Reboot when it asks you.
6) Updating Image will appear, wait 5 minutes
7) click on CH 122 and wait for picture.
