Recent content by trebor5961
-
T
[Problem!] Auto IP set-up not populating on Nano2
Rebooting did not help....however I did find my problem...it was an intemittent bad CAT 5 cable to Nano2. Was really difficult to find as I tested internet signal from router and all the way to entering Nano2 previously with laptop without issue.....appears that there was just enough damage to...- trebor5961
- Post #6
- Forum: CONAXSAT (CNX) Discussions
-
T
Found it....it was an intermittent bad CAT 5 cable...Back live, thanks for the GREAT support
Found it....it was an intermittent bad CAT 5 cable...Back live, thanks for the GREAT support- trebor5961
- Profile post
-
T
[Problem!] Auto IP set-up not populating on Nano2
No luck...tried reloading NPN_8.09_Factory, then NPN_8.10_Factory then NPN_1.29....set IP to auto & apply-waited, master power on/off many times...waited....still not picking up IP settings and no lights on adaptor...I'm baffled- trebor5961
- Post #3
- Forum: CONAXSAT (CNX) Discussions
-
T
[Problem!] Auto IP set-up not populating on Nano2
Lost picture with NPN_1.28 and NPN_8.06_Factory Did factory resent from Nano2 menu, then Loaded NPN_8.10_Factory then NPN_1.29. system files show: SW: MV01.29 (Jun16) LDR 1.08 HW ver: 1.00 USB 2.0 driver: 1.00...- trebor5961
- Thread
- boot-up cable captiveworks conaxsat dongles drivers flashing iks iks japan internet laptops manuals modems nano rebooting routers
- Replies: 6
- Forum: CONAXSAT (CNX) Discussions