Having trouble using Wikipedia today? That's because the popular crowd-sourced online encyclopedia is participating in an "Internet blackout" in protest of two controversial anti-piracy bills: The Stop Online Piracy Act (SOPA) and its Senate companion, the Protect IP Act (PIPA).
The bills...
Hello all,
I am new here and need a little help. I pointed my dish and am getting signal 85, quality 95. I installed my WF and loaded 100902 and 100909 files. antenna scanned and am only getting 110W channels and no 119. whenever i highlight the 119 in the att scan, 110 shows up on the top of...
I have been trying to add a channel and I am able to input the channel information, but then there is no save or way to see if it is actually programmed in the receiver(MAXHD.)
Does anyone have instructions on how to add a channel. Even the manual does not mention this feature in Channel Scan...
Hello, I've been trying to set up this multi-satellite dish for many weeks with no success! I have tried to center the FTA LNB for 97w but was unable to pick it up on either one of my two receivers the Limesat and the Satzen 500z. I tried using the AZ,EL & Skew calculations provided by...
Echostar 10,11 110.0W
LNB POWER: ON
LNB TYPE: STANDARD
LNB FREQ: 11250
22KHZ: OFF
TP FREQ: 12224
DISEQC: PORT 2
MOTOR: OFF
LEGACY SW: NONE
And the rest is the same.
I've tried everything no satilite 119 only on echostar 7 but still comes up in top right hand corner echostar 10,11 110.0W...
BAGHDAD – Iraq's government has recorded 87,215 of its citizens killed since 2005 in violence ranging from catastrophic bombings to execution-style slayings, according to government statistics obtained by The Associated Press that break open one of the most closely guarded secrets of the war...
How To Set up a Dish500
--------------------------------------------------------------------------------
Follow these directions carefully, How to setup your Dish500 Legacy or DPP Dish, with a few simple steps.
Note: If you have your Dish setup already, do the following. Next make sure there...
DTV Multi-Satellite
--------------------------------------------------------------------------------
phase III info...
All about the Phase 3 dish
(made for DTV, has 3 LNBs in same enclosure and built in multiswitch.)
YES, you CAN use this for your FTA setup to get 91 and 110 !
Advantages...
DishPro 1000.2 Description and How to Install
--------------------------------------------------------------------------------
It seems that recently, the 1000.2 is becoming a more popular dish option to fta and causes a lot of confusion. Hopefully, this how-to will briefly explain how they...
How to re-aim your BEV dish to receive DN.THANKS JRPCA
First, a word about safety. Winter is probably the worse time of the year to be climbing on your roof. If you absolutely have to then please, please use all the safety precautions you can. A ground man to hold the ladder, perhaps a safety...
What size Dish do I need and what LNB to get
Skip to bottom if you know the transponder frequency of the channel you want.
Satellites in North America have 3 transmission frequencies, so there are 3 separate LNBs required.
C-band = 3700mhz to 4200mhz (same as 3.7ghz-4.2ghz), these frequencies...
10 puntos basicos para memorizar del FTA (imprescindible )
1. Las llaves o “keysâ€� son las mismas para todos los receptores, asÃ* que no importa cual marca de receptor tengas.
2. Si el autoroll deja de funcionar, deja el keycode en "on" y las demas opciones en "off" e introduce las llaves...
i loaded the new puff boot and bin .... connected back to tv.. no signal on 119 or 110 ...so then i did a sysetem reset ......turned on echo 7 and 8.10 placed all settings where i always had them... went back and ran my blindscans and no transponders ......any help would be greatly...
bin
bin files
boot
boot-up
cable
diseqc
dish network
frequencies
internet
lnbs
pansat
programming
receivers
setups
skew
switches
television
transponders
:confused:--------------------------------------------------------------------------------
I finally got my VS 7000 pvr going, i formated and installed the hard drive i instilled the newest file....well i hope its still the newest and the only thing i left to do now is install the dish! but it...
How To Use Dishpointer.Com
I just wanted to do a quick Tutorial on how to use dishpointer.com, since alot of the questions in chat are about dish aiming.
First, go to Satellite Finder / Dish Pointing Calculator with Google Maps | DishPointer.com.
(DO NOT USE ANY OF THE VALUES THAT ARE...
How to Re-aim your BEV dish to receive DN
First, a word about safety. Winter is probably the worse time of the year to be climbing on your roof. If you absolutely have to then please, please use all the safety precautions you can. A ground man to hold the ladder, perhaps a safety line to keep...
Hello folks, I'm a freshly started newbie from Ontario, Canada trying to get signals for my CW800. I just stumbled upon a website where I learned that my dish is totally out of orientation and now I know why I've been trying for a week without success. Now that I know a bit more, I'll take the...
Swinging your Bev dish to DN.....
--------------------------------------------------------------------------------
Many Thanks to Trooper and Borderpatrol for doing all the ground work. I just fine-tuned it and did a few addons... hope it helps... hopefully it can used to cut down all the...