Fixing the incorrect bin loading issue

gopalmm2

New member
Modified C/P:
This procedure is in case you load the 214A private bin meant for dm100 v1 to dm100 v2. Can also fix any loader issue.

Open the Unit , there is label next to the resistor and it's going to be in the vicinity where the USB port is. Use a magnifying glass if you have to or as someone else wrote take a picture of the board then blow it up on your monitor.

rs562%20resistor.jpg


You can use a soldering iron (recommended) to remove the resistor or just yank it off cleanly. The resistor is useless and unnecessary.

Just make sure you identify the correct one, it's going to be sitting right next to another resistor so be careful.
The golden one, C556, you don't touch.
The one to remove is the immediately next to it colored black. It has label R562 next to it.

Of course, a little bit of a disclaimer, anyone attempting this takes all the risk and consequences.
 
Back
Top