CASPER
New member
Tips to remember when asking for help in the forums:
When asking a question,you should follow these minimum requirements
1.What Satellites you are aiming at.
2.Your Receiver Brand/Model
3.What version of software you have loaded on it,
("the latest version" is NOT an acceptable answer)
4.What dish and lnb type you have.
("a plain lnb" is not a proper answer)
5.Any switches you have inline. (name the brand/type)
6.What settings you currently have setup.
7.What you have tried so far(Detailed steps)
8.Other things pertinent to your specific question
may also be needed and included.
To post a reply you must follow these guidelines
1. Your answer must be pertinent to the originators question.
(do not answer a question posted by someone else in this thread,(dont reply to hijacker)
2.No bashing the member or question. (we were all newbies at one time)
3.Do not reply to a hijackers question.
4.Post no files in discussion area.You may post a link to a file you
upload in the proper files section.
A properly stated question would look something like this.
I am running a Viewsat Extreme with version 070522x software loaded.
I have a dish500 with a twin Dp lnb.
I have 119 set on diseqc port1 with LNB selected as OCS-DP
and 110 on port2 again OCS-DP selected.
no other switches inline.
My question is,why cant I get 91 when i select it from the list?
Following this template will greatly increase the chances of a solution!
.
.
When asking a question,you should follow these minimum requirements
1.What Satellites you are aiming at.
2.Your Receiver Brand/Model
3.What version of software you have loaded on it,
("the latest version" is NOT an acceptable answer)
4.What dish and lnb type you have.
("a plain lnb" is not a proper answer)
5.Any switches you have inline. (name the brand/type)
6.What settings you currently have setup.
7.What you have tried so far(Detailed steps)
8.Other things pertinent to your specific question
may also be needed and included.
To post a reply you must follow these guidelines
1. Your answer must be pertinent to the originators question.
(do not answer a question posted by someone else in this thread,(dont reply to hijacker)
2.No bashing the member or question. (we were all newbies at one time)
3.Do not reply to a hijackers question.
4.Post no files in discussion area.You may post a link to a file you
upload in the proper files section.
A properly stated question would look something like this.
I am running a Viewsat Extreme with version 070522x software loaded.
I have a dish500 with a twin Dp lnb.
I have 119 set on diseqc port1 with LNB selected as OCS-DP
and 110 on port2 again OCS-DP selected.
no other switches inline.
My question is,why cant I get 91 when i select it from the list?
Following this template will greatly increase the chances of a solution!
.
.
Last edited: