CASPER
New member
Limesat HD Setup Guide
(1)Download and install 2.01 file .... Plug in flash drive and from popup select 2.01 file.
(2)Go to installation menu & select manual scan.
(3) Hi-lite your sat select turbo 8psk & save changes.Do this for each of your sats.
(4) Go to Installation > Dish Settings & put in your settings & scan.(red button) Note: If you notice that you are missing any transponders, you can go back to manual scan, choose the missing TP on whatever Sat & scan it.
(5) Do all your settings, time etc.
(6) Go to server settings,Menu>Configuration>server settings> blue button for Server setup, select each one & put in your settings. Note: Leave 1 and 2 open , use 3 and up.
(7) After each setting just exit. When all are done, save. Note: If you have to select any symbols, like the #, it won't show until you exit.
(8) Go back to server settings window & scroll right to turn on server.
(9) Select re-activate server.(red button)
(10) Repeat for each server.
(11) If you have more than 1 server, you can enter them all. It is not necessary to disable any of them.When you select a channel the box will cycle through all your servers to find which one has the channel open.
(12) It will say "network connect, 0 servers". This a bug, when you exit & go to a channel, it will be there.
(13) Bev channels use a 1 prefix for the regular channels & a 2 prefix for the HDs.
Instruction zip file included if you want to save them.
(1)Download and install 2.01 file .... Plug in flash drive and from popup select 2.01 file.
(2)Go to installation menu & select manual scan.
(3) Hi-lite your sat select turbo 8psk & save changes.Do this for each of your sats.
(4) Go to Installation > Dish Settings & put in your settings & scan.(red button) Note: If you notice that you are missing any transponders, you can go back to manual scan, choose the missing TP on whatever Sat & scan it.
(5) Do all your settings, time etc.
(6) Go to server settings,Menu>Configuration>server settings> blue button for Server setup, select each one & put in your settings. Note: Leave 1 and 2 open , use 3 and up.
(7) After each setting just exit. When all are done, save. Note: If you have to select any symbols, like the #, it won't show until you exit.
(8) Go back to server settings window & scroll right to turn on server.
(9) Select re-activate server.(red button)
(10) Repeat for each server.
(11) If you have more than 1 server, you can enter them all. It is not necessary to disable any of them.When you select a channel the box will cycle through all your servers to find which one has the channel open.
(12) It will say "network connect, 0 servers". This a bug, when you exit & go to a channel, it will be there.
(13) Bev channels use a 1 prefix for the regular channels & a 2 prefix for the HDs.
Instruction zip file included if you want to save them.
