[Help!] Scrambled Channels on Sat 110

Status
Not open for further replies.

juan98901

New member
I need some help.....I am fairly new at this and it is driving me crazy...

I am getting a lot of scrambled channels out of Sat 110 and the wierd thing is that if I hit the menu botton and then I exit out right away, the channel will come in....However, if I change the channel to one that comes in on Sat 119 then I switch channels back..... it will have scrambled channel agian...

Here are my setting for sat 110

Satellite name...............23 Echostar 6,8 (110)
Tansponder..................12224/v/2000/5/6
LNB Type.....................Normal
22khz..........................On
Disequ.........................LNB1
Legacy SW...................SW42 Dish1
Motorised.....................None

I would really appreciated any help...Thanks
 
if you have dual lnb then change the 110 to lnb 2 and the 119 to lnb 1 turn receiver off from rear for about 3 minutes then turn back on ...........PS what model of cw do you have>????????
 
I have the cw800s with a single lnb....I also noticed that if I get the "scarmbled channel" message and I turn off the receiver with the remote and turn it back on, the channel comes in........ but as soon as I change the channel up or down then I change it back.....I will agian get the "scambled channel"....It does the same thing when I hit the menu bottom......like I explained in me first post.....Like I said I am fairly new at this so bear with me....... thanks
 
ok whats wrong is if you have one lnb how are you getting 119 that means your receiver was scanned for two lnb that's two sat's you can only use the ones that are in 110 if that's the one you choose. the other is you need to do factory default but go to system settings and do factory reset and scan the bird that you want....
 
Status
Not open for further replies.
Back
Top