Folks;
I am having serious challenge.
I have a pansat 6000hxc for approximately two years or so and have used/enjoyed it famously up and until February 13. Up till then I noticed a number of the fix files had the extension "api"/"apib" on them. Since then there have been two fta fix files with the extension "femu" which just have not worked. In fact, when installed the screen goes black without even the usual "scrambled or bad channel" message and no percentage countdown as a new file would.
It is as if these files were not meant for this receiver. In fact, in attempting to restore factory settings the receiver stopped responding to all controls: remote and on the receiver itself. I had to use a rs232 cable to burn in an older fta fix before recovering control.
I can't imagine I am the only one affected with this problem and to be clear let me say: I have tried both the hard reboot and system factory reset. The same problem remains once I do a software upgrade to any of the "femu" fta fix files. The screen is blank without even the "scrambled or bad channel" message.
Help!
Ecneralc
I am having serious challenge.
I have a pansat 6000hxc for approximately two years or so and have used/enjoyed it famously up and until February 13. Up till then I noticed a number of the fix files had the extension "api"/"apib" on them. Since then there have been two fta fix files with the extension "femu" which just have not worked. In fact, when installed the screen goes black without even the usual "scrambled or bad channel" message and no percentage countdown as a new file would.
It is as if these files were not meant for this receiver. In fact, in attempting to restore factory settings the receiver stopped responding to all controls: remote and on the receiver itself. I had to use a rs232 cable to burn in an older fta fix before recovering control.
I can't imagine I am the only one affected with this problem and to be clear let me say: I have tried both the hard reboot and system factory reset. The same problem remains once I do a software upgrade to any of the "femu" fta fix files. The screen is blank without even the "scrambled or bad channel" message.
Help!
Ecneralc