having some difficulty here...i put the newest file on it..080507 or whatever it is...and i heard some talk about if you blind scan you will pick up some moved channels...so i tired that after that was finished i have double channels..and i did a factory default to reset it and try it all over again but still after i scan it 2 times i still get double channels anyone help me
double channels viewsat ultra
- Thread starter tangerai
- Start date
it happened to me once, it had to do with the echo sat settings. For example I changed the port by mistake and my settings changed for the echo 8,10 and echo 7... i then noticed all the numbers and such had the same values and that was the cause of the double channels so it might be the same thing thats happened with you.
archange187
New member
Blind scans work but you have to delete your current channels before you do that. From experience i can tell you blind scans on viewsats are the worst! Fortec's had an awsome blind scan. On the viewsat if you do an Auto-scan works a lot faster and may fill in those missing channels. You could also try a channel list insted! Doing a factory default will only cause you misery!
-Angel
ur telling me misery dude.....i cant even get to the selecet language part of the installation when i do a factory reset or factory default....just goes to no channels listed..then when i hit menu then installtion then antenna setup...my configuration is as follows :
echo star 7 (119 w)
lnb power on
lnb type universal
lnb high 11250
lnb low 9750
tp freq 12224
diseqc port 2
motor off
legecy sw none
is that correct..
echo star 7 (119 w)
lnb power on
lnb type universal
lnb high 11250
lnb low 9750
tp freq 12224
diseqc port 2
motor off
legecy sw none
is that correct..
archange187
New member
ur telling me misery dude.....i cant even get to the selecet language part of the installation when i do a factory reset or factory default....just goes to no channels listed..then when i hit menu then installtion then antenna setup...my configuration is as follows :
echo star 7 (119 w) <- correct
lnb power on <- correct
lnb type universal <- depends on your LNB (most work on univ.)
lnb high 11250 <- Is the right freq for Dishnet
lnb low 9750 <- Option is only valid on univ. lnb's
tp freq 12224 <- transponder 12224 is spotbeamed, Switch one up or down to recieve signal
diseqc port 2 <-depends on your settings
motor off <- You don't have a motor
legecy sw none <- Only used in Quad lnb's or Sw21 switches
Hope that helps
i dont know if i have it or not but im about to find out...i put 119 on port 1 and 110 or port 2 i think they how it was when my dad did it for me but i cant remember...but when i put it on port 1 for 119 i get no Q and 110 is good for both S and Q..then i go to auto scan and and click the sats i want scanned 110 shows good S and Q and then when i go to 119 i get no Q...then i said oh well...scan it...and i think it might have worked just have to save my settings here and let ya know
archange187
New member
In order to get quality on 119, you must change the transponder off of 12224 by selecting that with the remote then push either left or right. When you get quality then autoscan the sat. You must repreat this for every sat you scan.
-Angel
