How to load new CW800 with usb or cable

[CASPER]

Download/Unzip files.Transfer files onto USB stick then plug it into the box. You should see a message that says USB ready. Now press the USB button on remote and then scroll to the right to open Software tab.Look for file and press OK to load it. After it loads it will ask you if you want to reboot say YES. When it reboots then go in menu and do a Factory Default. Then reboot again . When it comes back up now you can setup sats and options and rescan all sats. After done with that exit out of all menus and with remote press F1 000 to enable the Patch. You should see a message on tv that say PATCH ENABLED. Now wait for keys to roll and watch tv


cable instructions
Prepare receiver:
Turn off and attach the null-modem cable between the receiver and the computer serial port.Then plug in the power plug.
With the CaptiveWorks 800 receiver off, press the front power button and hold it.
While holding it, turn the rear toggle switch on, while STILL holding front power button.
You will see "boot" on the front display.

1. Get the current loader - UpgradeCW800S
2. Download the latest bin
3. Load the latest bin with the current loader as per these instructions:
Open the loader, select the latest bin in the "File" bar across the top.
For Options, select Download S/W.
For Select a port, choose your COM port (usually 1).Then hit the start/load &
wait for the receiver to display "-end".
At this point, turn reciever off at rear switch.
Unhook cables and hook back to tv .
Then turn on and set up as normal.