Can anyone give me some instructions how to set up Viewsat Ultra with 110, 118.7, 119 connected to DP34 switch??? What satellite and switch setup I need to enter??? What files do I need and where I can find them??? I loaded the newest bin, but I cant find the right sat info. Can anyone give me the link to the files i need, please???
[Help!] How to set up Viewsat Ultra with 110, 118.7, 119 and DP34 switch???
- Thread starter dvd_mi
- Start date
archange187
New member
Good luck.... Special considerations on that switch...
1. Can only be used with DISH Pro LNBFs (DISH Pro Twin LNBF for two orbital locations (110° and 119°), DISH Pro Twin LNBF with a DISH Pro Single LNBF for three orbital locations or up to three DISH Pro Single LNBFs).
2. When used with a DISH Pro Twin, the LNBF operates in its default state: one port provides 110° and one port provides 119°. Either port of the DISH Pro Twin can be connected to any two LNBF ports of the DP34 Switch.
3. Tuner Outputs: DISH 301 and DISH 501 have one tuner, and would use one DP34 tuner output; DISH 721 has two tuners, and would use two DP34 tuner outputs.
4. A "legacy" receiver (non-DISH Pro receivers, released before DISH 301) can be connected to a DISH Pro DP34 Switch, when used with a DISH Pro Adapter.
Here is a pic of the LNB required for that switch..
The reason it needs that lnb becasue that lnb has a built in SW21 for each side at a 22khz tone. To use any other lnb's you need to add 2 sw21's and set up tones. I wish ya the best but that is not the best switch for the job.
-Angel
