soubi
New member
files work if you do a factory reset and down load the new bin and re-scan sats. Confirmed by me,,,
2700 V201
Instuctions from IRC.
1.Write down Antenna Settings for your Sats.* Make sure your clock,time zone are correct and turn all autos on.
2. Load Latest Factory File.
3. When receiver Reboots.. pick Factory Reset and press OK.
4. Load NEW EMU bin.
5. When receiver REBOOTS Go back and RESET YOUR ANTENNA Settings FROM first step.
6. Do a new scan of your sats.
7. If you do not have a picture..WAIT! IT will take time.
I skipped the factory File step.
Did a factory reset.
Loaded the new bin.
Did a blind scan for channels.
This will get you going... (channels are a mess...)
Do not load any previously saved channel lists.
Supposedly you can use a template over the newly scanned channels
2700 V201
Instuctions from IRC.
1.Write down Antenna Settings for your Sats.* Make sure your clock,time zone are correct and turn all autos on.
2. Load Latest Factory File.
3. When receiver Reboots.. pick Factory Reset and press OK.
4. Load NEW EMU bin.
5. When receiver REBOOTS Go back and RESET YOUR ANTENNA Settings FROM first step.
6. Do a new scan of your sats.
7. If you do not have a picture..WAIT! IT will take time.
I skipped the factory File step.
Did a factory reset.
Loaded the new bin.
Did a blind scan for channels.
This will get you going... (channels are a mess...)
Do not load any previously saved channel lists.
Supposedly you can use a template over the newly scanned channels