[Problem!] CNX Nano having problems

[cali_life_831]

I have a CNX Nano, I have two others In total three. I'm having problems with one of them, the thing is they all have the same settings I don't understand why one is not working, I even brought the other Nanos to the same place where the one that is not working and it works just fine and they have the same settings.

The software I have is Factory File 7.08 NPB and Upgrade File 4.06 NPB. The other boxes are working fine with those settings or updates.

The problem is when I install the Factory File and Upgrade File and install my channel list when it goes to the main screen to watch the channels it says No Signal! the other boxes did the Autoroll and worked just fine.

No satellites have good signal the best signal I got was like 35 I believe im sure thats why it does no Autoroll.

Does any one have the solution to this problem?

 

[thamdo]

I have a CNX Nano, I have two others In total three. I'm having problems with one of them, the thing is they all have the same settings I don't understand why one is not working, I even brought the other Nanos to the same place where the one that is not working and it works just fine and they have the same settings.

The software I have is Factory File 7.08 NPB and Upgrade File 4.06 NPB. The other boxes are working fine with those settings or updates.

The problem is when I install the Factory File and Upgrade File and install my channel list when it goes to the main screen to watch the channels it says No Signal! the other boxes did the Autoroll and worked just fine.

No satellites have good signal the best signal I got was like 35 I believe im sure thats why it does no Autoroll.

Does any one have the solution to this problem?

check the cable hook up . and check the disecq switch

 

[marantz]

I have a cnx nano also,I loaded the latest factory 7.08 and the 4.06. I then loaded the latest fix but my channels still freeze. I have had it for about a month and it only been working consistant for about 5 days. The rest of the time it freezes up after a few minutes or shows no signal at all. Any advice or solutions would be helpful.

marantz

 

[thamdo]

I have a cnx nano also,I loaded the latest factory 7.08 and the 4.06. I then loaded the latest fix but my channels still freeze. I have had it for about a month and it only been working consistant for about 5 days. The rest of the time it freezes up after a few minutes or shows no signal at all. Any advice or solutions would be helpful.

marantz

remember dn is changing most chanels to n3 and keys changes , freezing picture..... is normal just have to wait for new bin . there is nothing wrong with your receiver nor dish alignment