what I recommend you to put all the the lines coming from both dishes on one disq switch that's were your problem is cuz you are using port 3 but it's probably not on the same switch right. so if you put all three lines on 1 switch then you select the lnb 1sat 119 echo 7 first then disq lnb 2110 echo 6,8 then which ever you want next bev or what ever on lnb 3.and before you do this deleat all channels and re-scan each as above....
Setup for Sonicview 360 Elite
Loading
Download and unzip file and put it on your USB stick
Insert the USB drive into the front USB port of Sonicview 360 Elite
Press Menu; Choose PVR; Choose USB Drives; Press OK; Highlight file and press OK to download.
After the receiver downloads and reboots take your USB out, turn off from back, count to five and turn back on.
Set Time, Locals, Autoroll, Parental Control
Press Menu; Choose System Settings; Choose Time Settings; Choose your time zone exit.
Press Menu; Choose System Settings; Choose User Options; Set all to ON Choose your local and exit.
Press Menu; Choose System Settings; Choose Parental Conrol; 0000; Set all to OFF, and ACC to Disable.
Scanning
Press Menu; Choose Installation; Choose Dish Setting
Start with Tuner 1
Echostar 7
OCS DP
11250
12224 or 12239 TP
Port 1
Press the red button to scan the satellite save when done
Echostar 8,10
OCS DP
11250
12224 TP
Port 2
Press the red button to scan the satellite save when done
Tuner 2
If you used two wires from your dish choose separate
If you have one wire from dish and used the loop through (can only record channel and watch channel on same TP ) Choose Loop Through
Scan as above
Exit out
Put on Channel 118 for keys to Roll
it should look like this if you are using dish 500
sat echo 119
transponder 12224/20000/5/6
Lnb freq11250
Lnb type ocs-dp
22khz auto
diseqc number Lnb1
legacy sw off
motorised system none
sat echo 110
transponder 12224/20000/5/6
Lnb freq11250
Lnb type ocs-dp
22khz auto
diseqc number Lnb2
legacy sw off
motorised system none
also attaches is the sv360 elite manual...
.
